When exporting a DGN file from AutoPIPE (v12.2) the origin is shifted by what seems to be an arbitrary amount (when imported to AutoCAD 2020). I'm looking for a fix. AutoPIPE is configured with Z as up and I'm using standard AutoPIPE (English) units. The model is shifted WAY to the south-west. Choosing a random point (global position): AutoPIPE says the location is X=65.3 Y=229.4 Z=144.2 (Units in ft) AutoCAD says the location is X=-9940.2 Y=-45941.1 Z=144.2 (Units in ft) This offset is consistent between dgn exports and different models. When Y is set to up, the offset is similar but not the same. Here is the same point with Y as up: AutoPIPE says the location is X=229.4 Y=144.2 Z=65.3 (Units in ft) AutoCAD says the location is X=-9706.1 Y=-46096.2 Z=65.3 (Units in ft) The model offset does not occur when exporting as DXF. I cannot figure out where this offset comes from.
↧