Hello Jaroslaw.K, Are you talking about the following displayed in the Tools Model consistency check report: * * * W A R N I N G - MODEL * * * W726-12: Following Segment(s) not connected to other segments and has no anchors This is not an error but a warning for the user to know that the following has occurred. Regardless try and run the analysis. If the analysis runs without a displayed error, then the tie-rods were correctly connected and supported from the beams. If you see the following displayed, E801-1: FATAL ERROR : Unstable system. Need support at node xxx Dir xx Then yes, there is a problem that needs to be addressed. Otherwise, you are fine. On a different subject, you should have noticed from the webinar that the tie-rods have assigned rigid properties to include both weight and thermal movement. Regards, Mike Dattilio Bentley Technical Support Analyst Web: selectservices.bentley.com Create your Service Request online! Log in to SELECTservices Online via selectservices.bentley.com and then go to My Support Account Service Request Manager. You'll have the ability to create a new Service request, view all Service Requests created by you or anyone else in your company, and view statistics on previous requests.
↧