Applies To Product(s): AutoPIPE, Version(s): 2004, XM, & V8i Environment: N/A Area: Warning Message Subarea: Original Author: Bentley Technical Support Group Problem: The following is displayed when using AutoPIPE --------------------------- Warning --------------------------- W21-38: This function cannot be applied at the current point. --------------------------- OK --------------------------- Why does it appear and What should i do now to avoid it? Answer: There are some commands in AutoPIPE that can not be performed at certain locations in the mode A. Inserting a Tee at a Bend Near / Far / Mid / TIP Point. B. inserting a new segment at the end of a valve. C. Splitting a Segment into 2 segments at a Bend Near / Far / Mid / TIP point D. etc... The only work around its to not perform the operation at this point. Try selecting a normal Run point. See Also Bentley AutoPIPE External Links Bentley Technical Support KnowledgeBase Bentley LEARN Server Comments or Corrections? Bentley's Technical Support Group requests that you please submit any comments you have on this Wiki article to the "Comments" area below. THANK YOU!
↧