Applies To Product(s): AutoPIPE Version(s): CONNECT; Area: Isometric Original Author: Bentley Technical Support Group Date Logged & Current Version Feb. 2016 10.00.00.10 Problem: How to relocate north arrow to a different position & rotate to a new direction on an AutoPIPE Stress Isometric using OPIM? Solution: Relocate to a New position In order to relocate north arrow you have to perform following steps. 1. In AutoPIPE launch Openplant Isometric Manager from menu “File > Launch Openplant Isometric Manager” 2. Open any border file you want to modify from “[Installation Directory]\isoextractor\Borders\...” i.e. I have selected DGN\A0BORD.DGN 3. Press Settings>View Attributes 4. On View Attributes dialog select “Text Node” and close the dialog. You can see in the snapshot below 5. On top left you see North Arrow place holder along with the text nodes 6. Select the place-holder along with the text nodes 7. Now you can move the selection set to any place in the border. 8. After setting proper place close OpenPlant Isometric Manager. 9. Make sure to use the same border during export to Stress Isometric using AutoPIPE. Rotate North Arrow This requires a lot of manual manipulation in AutoPIPE v.11.02.xx.xx and lower OPIM versions. However, use the following process when using AutoPIPE 11.03.00.xx and higher. AutoPIPE v11.03.00.xx and higher Open "style.xml" from the following folder location: "C:\ProgramData\ Bentley\ AutoPIPE xx\ isoextractor\ projects\ project01\ stress\ Config\ style.xml" Find the following setting under
↧