W21-38: This function cannot be applied at the current point. W31-86: No allowable stresses are available for the selected material in the material library W41-27: Parameters are outside the applicable range W79-85: 0 Stiffness in direction of imposed harmonic load. at XXX W726-2: Gap orientation has changed for guide at point XXX W726-6: Near zero length element at point XXX W726-7: Pipe diameter change without a reducer at point XXX W726-8: Kink in straight run of 90.0 deg at point XXX W726-8: Kink in straight run of 179.9 deg at point XXX W726-38: Allowable at ambient is outside of temperature range at point XXX for material YYYY W726-93: Zero weight flange found at point XXX W726-94: Zero weight valve found at point XXX W726-110: Not all gaps are non-zero for following support(s) W726-170:The tee at point A04 has only two legs defined which may not meet the conditions to apply the equations for SIF and other stress indices. W726-195:Support D10 1-Zero length from 'supported' to 'connected' point W727-2: Temperature is outside the range specified the code for Expansion for AutoPIPE W727-3: Temperature is outside the range specified by the code for allowable W774-47 One or more combinations are set to none W801-58: Smallest timestep for xxxx .TIH file = .... W831-11: Seismic level includes cases not analyzed W2018-11, W2018-12, W2018-16: Not authorized for ???? edition, AutoPIPE reverts to DEMO mode W2143-37:Extremely high value for Displacement tolerance 1000 detected in loadset W2143-76:Friction scale factor is zero. Friction at all supports will be ignored for following analysis set W2164-12:System contains Gaps/Friction/Soil data. Please enable non-linear option in the following Analysis sets
↧