Hello Quique0185, When replying to a post please navigate to the post location and use the Reply function, otherwise you create a completely new thread. Thanks for your cooperation. About your issue, you can model vibration by performing a Harmonic Analysis. Help > Contents> Contents Tab> Modeling Approaches> >Example Systems> Harmonic Analysis Example. Recommend that you actual perform this analysis while reading it to get a better feel for using AutoPIPE. Again, please refer to the WIKI page: https://communities.bentley.com/products/pipe_stress_analysis/w/pipe_stress_analysis__wiki/10544.w801-121-v-stop-liftoff-s-have-occurred-under-operating On this site it states that "Most designers try to avoid large lift-off because of this issue and so they move the supports or replace with a spring hanger type support." From your previous post, I assume that you are a new user of AutoPIPE. If so, highly recommend attending an official training class. See the following Link: https://communities.bentley.com/products/pipe_stress_analysis/w/pipe_stress_analysis__wiki/7424.new-autopipe-user-suggested-information-autopipe Regards, Mike Dattilio Bentley TSG Support Analyst ===================================================
↧