Image may be NSFW.
Clik here to view.
Problem:
The following is displayed in model consistency check report:
W726-7: Pipe diameter change without a reducer at point XXX
Solution:
This warning message is displayed whenever there is a difference in pipe properties OD or wall thickness between two sucessive points in a model without a reducer.
Avoidance:
Option #1:
Insert a reducer between the 2 different pipe properties.
Option #2:
Accept the warning as OK, and ignore the warning as the joint is correctly modeled. Insert a user Joint type / SIF added as needed.
See Also
External Links
Bentley Technical Support KnowledgeBase
Comments or Corrections?
Bentley's Technical Support Group requests that you please submit any comments you have on this Wiki article to
the "Comments" area below. THANK YOU!