Topics under the heading should be based on:
Printing reports or graphics to a printer
Question: I want to see the parts of the model highlighted red color only in the output report.
Answer: With a model open in AutoPIPE, analyze the model. Afterwards, press Select> select node points, segment, components, etc. as required in the model, press Results> Output Report> enable (check ON) "Limit results to highlighted points" (see online help for details on this option), continue with enabling additional sub reports as need, and press OK button.
Note: you will need to select the over stress points shown as red in the code compliance color, consider using the Results> Filter command in addition to the Select command for highlighting parts of the model.