Applies To Product(s): AutoPIPE, Version(s): 2004, XM, & V8i Environment: Enhancements Area: Subarea: Original Author: Bentley Technical Support Group The following Flange Analysis enhancements have been logged for inclusion into a future version of AutoPIPE: Note: if an enhancement has not been added to the program, log an Service request for that enhancement. The more requests logged per an enhancement, the quicker the CAE development team will add that feature to the program. 1. CAE-CR-11051 Flange Analysis: 3000 psi limit on Operating pressure in the Loads tab Description: The Operating pressure can take large values and AP does not allow the values greater than 3000 .There should no Upper limit on the Operating Pressure Field. Development Project: 9.6. 2. TFS-E68103:Flange Analysis - Add API-6A Flanges in the database Descr i ption: Add API-6A flange sizes for use in both ASME and ANSI flange analysis calculations Development Project: TBD 3. TFS-E68113: Flange Analysis: Include the Stoomwezen D0701 flange check Description: Add Stoomwezen D0701 flange check in the Flange Analysis module Development Project: TBD 4. TFS-E175524: Flange Analysis - Add Bolting Materials to library based on Size / Thickness values Description: Flange Analysis - Add Bolting Materials to library based on Size / thickness values. Example: Bolting material = SA-193-B8M-2 For ASME Section III - 2010, Table 3 has 4 different lines of data for this material based on Size / Thickness. The different Thickness ranges have different corresponding Tensile Strength, Yield Strength, and Allowable values based on temperature. The user would like all 4 added of these added to the program. Workaround: Until the library file has been updated, set Bolting Material = User and manually enter the correct values on the dialog. Development Project: TBD Logged: Feb 2015 See Also Bentley AutoPIPE External Links Bentley Technical Support KnowledgeBase Bentley LEARN Server Comments or Corrections? Bentley's Technical Support Group requests that you please submit any comments you have on this Wiki article to the "Comments" area below. THANK YOU!
↧