Hello Diana, I have moved your question from the original location to the Pipe Stress and Vessel forum. It is tough to answers questions like this with out looking at the model and reviewing your analysis settings. Please be sure to read the AutoPIPE help on this settings, you may not have turned on "Pcas in Sustain" as instructed by the help. In addition you may not be looking at both sides of the node point about an elbow. Meaning that an elbow is made up of 4 points, Near, Far, TIP, and Mid. Be sure that you are reviewing results for the Near and Far node points on the pipe side of the node point and not just on the elbow side. If you still need assistance, suggest that you log a service request and send your AutoPIPE APC file for review. communities.bentley.com/.../7715.z-technical-support-autopipe Regards, Mike Dattilio Bentley Product Advantage Group Analyst ===================================================
↧