| Applies To | |||
| Product(s): | AutoPIPE, | ||
| Version(s): | 2004, XM, & V8i | ||
| Environment: | N/A | ||
| Area: | Post Processing | ||
| Subarea: | |||
| Original Author: | Bentley Technical Support Group | ||
Comments, Questions and Answers
- Question:
AutoPipe Results> Code stresses floating dialog shows the Max Expansion Stress to be 4785 psi on the screen however, the report shows 2 stresses (+ /- side) for that node point, one of which has a higher stress of 5004 psi ?
Answer:
The CAE development team has confirmed there is a problem on the floating results dialog for displaying the highest value stress between +/- side (up stream / Down stream) of a node point for bend mid point . The output report and results grids are correct.
This has been loged under CAE-TR-11039.
See Also
External Links
Bentley Technical Support KnowledgeBase
Comments or Corrections?
Bentley's Technical Support Group requests that you please submit any comments you have on this Wiki article to
the "Comments" area below. THANK YOU!
