Applies To Product(s): AutoPIPE, Version(s): 2004, XM, & V8i Environment: N/A Area: Modeling Subarea: Original Author: Bentley Technical Support Group Attention: Please see the following AutoPIPE help section: Help Contents Contents Tab Modeling Approaches Modeling Approaches This help has been provided in order to give users ideas for modeling typical piping arrangements. The steps shown in each example should not be taken as the only method available to create models. In addition, the intent of the examples is to present ways to create adequate models of specific piping components for analytical purposes. Anchors Bends Cuts Flexible Joints Frames Hangers Nozzles Pipes Reducers Rotating Equipment Supports Tees Valves Vessels What are some addtional modeling approaches, tips and techniques for different types of piping components? PIpe Tees and branch fittings (weldolet, sockolet, etc..) Flanges Bends Flexible Joints Reducers Valves Victaulic Couplings Nozzle GrayLoc Connector See Also Bentley AutoPIPE External Links Bentley Technical Support KnowledgeBase Bentley LEARN Server Comments or Corrections? Bentley's Technical Support Group requests that you please submit any comments you have on this Wiki article to the "Comments" area below. THANK YOU!
↧