Hello Jan, unfortunately there is no easy solution to all your questions: 1. Nozzles A and B - The program cannot perform calculation of nozzle opening on external jacket, so please create a separate model with the same design T,P as the chamber 1 and geometry and model the nozzle as a set in type and perform separate analysis. We are looking forward to improve the capability of the software so that in the future this capability would be offered. 2. Nozzle F - This is a 3D graphics defect, the actual calculation takes into account which head it is located on, eg. if you select chamber 1 or chamber 2 as nozzle material for nozzle F you will find in the reinforcement calculation of the nozzle the appropriate head is considered. Also you will find that the warning for a separate external reinforcement calculation will not be shown if you locate the nozzle F on the jacket (chamber 1) head which is appropriate. We will fix the 3D graphics issue shortly. 3. Nozzle V - this is a defect with the 3D graphics, but the calculation is fine, I have logged in this defect and it will be resolved soon. thanks, Sudip
↧