Applies To Product(s): AutoPIPE Version(s): ALL; Environment: N/A Area: Results Original Author: Bentley Technical Support Group Date Logged & Current Version July. 2017 11.00.00.22 Problem: After analyzing a model in AutoPIPE, one could review results on an interactive floating dialog; Results> Code Stresses Displacements Restraint Support Forces and Moments Soil Mode Shape Appears not all combinations are not visible on the this floating interactive dialog, or when using PgUp / Pgdn keys, why? Example: Analysis Set #1 load cases analyzed where: Gr, T1-T4, E1, W1, P1-P4. However, only the following combinations can be seen on the floating interactive dialog: Where are the combinations for GrT2P2, Amb - T2, T2-T4, etc..? Solution: There are a number of settings that control combinations. Confirm all these settings to be as desired: 1. Under Results Options These settings will only affect Code Stress Combinations. See AutoPIPE help to understand these settings in detail. 2. On the Analysis Set dialog Confirm Analysis Set to be analyzed was set to do so: 3. On Load Combination dialog a. Load Case tab, confirm all the load cases are listed b. Code Comb. tab, confirm all Code Combinations are correctly listed. While on this tab, suggest to press Delete All button, and then Reset Defaults Only button. Also verify that print is enabled for all combinations c. Non-code Comb tab, confirm all non-code combinations are correctly listed. While on this tab, suggest to press Delete All button, and then Reset Defaults Only button. Also verify that print is enabled for all combinations 3. Remember Only combinations on the Code Comb. tab with print enabled will show up on the interactive floating dialog for Results> Code Stresses Only combinations on the Non-Code Comb tab with print enabled will show up on the interactive floating dialog for the other categories (Displacements, Restraint, Support, Forces and Moments, Soil, Mode Shape) results. See Also Floating Interactive Results Dialog Bentley AutoPIPE
↧