Applies To Product(s): AutoPIPE Version(s): 2004, XM, V8i Environment: N/A Area: Modeling Original Author: Bentley Technical Support Group Date Logged & Current Version Mar. 2015 09.06.01.10 Problem: How to model a socket elbow, or other Socket welded fittings (i.e. Tee, valves, Sockolet, etc..) in AutoPIPE? Solution: Apply manufacture recommended SIF values or refer to a specific piping code for recommended SIF values to be applied Threaded fittings The intent on many ASME codes to use conservatively an SIF value = 2.3 Socket Welded fittings: The intent on many ASME codes to use conservatively an SIF value = 2.1 ASME Codes state the following regarding socket welds: B31.1 use 1.3 for socket welds with no undercut, and 2.1 for all others. B31.3 states "2.1 Max or 2.1 T/Cx but not less than 1.3. Cx is the fillet weld leg length" B31.8 states "2.1 Max or 2.1 T/Cx but not less than 1.3. " To apply an SIF to all bends and Tees perform the following: Press Select> Bends> to highlight all bends in the model, Press Select> Tees> to highlight all tee in the model Press Insert> Xtra data> Joint Type and User SIF> select "Joint End Type" = (select 1 of 10 choices) (ex. "Socket or Fillet Weld ", " Threaded Joint") Note: 1. see AutoPIPE help for a complete list of options available for selection. 2. For joint types not listed select "User-Defined" Manually enter the "Inplane SIF" = (manufacture / code recommended value, ex. 2.1) M anually enter the "Outplane SIF" = (manufacture / code recommended value, ex. 2.1) Optional: select "Override all other SIFs at this point", see AutoPIPE help for details on this option. Press OK button to apply SIF values to all highlight components. To account for the extra weight of a 2000# to 9000# fitting: Create a new pipe property with the correct wall thickness Press Select> Bends> to highlight all bends in the model Press Select> Tees> to highlight all tee in the model, Press Modify> "Pipe Properties over range", select the new pipe property ID, and press OK button to assign the new pipe ID to the selected components. To account for Threaded / Grove reduced wall thickness in Hoop calculation As an example, according to ASME B31.3 - 2014 sec. 320.1, Basic Assumptions and Requirements Sustained conditions may be evaluated by detailed analysis, approximate methods, or simplified means such as span tables. Section moduli used to compute the stresses in this paragraph shall be based on nominal pipe dimensions less allowances, i.e., the sum of mechanical (thread or groove depth), internal and external corrosion, and erosion allowances. The code continues with formula that include the SIF's Again as an example, in AutoPIPE , using ASME B31.3-2014, section modulus is calculated using the nominal thickness less corrosion allowance if "Use Nominal Thickness" is unchecked. Pipe Property "Mill tolerance" is not considered ever for B31.3 section modulus calculations. Therefore, when applying an user SIF, by setting "Joint End Type = Threaded Joint" will affect only the SIF and not the section modulus, Adding the corrosion and thread / grove depth together, placing that value in the corrosion field of the Pipe Properties dialog should calculate the appropriate section modulus for all pipes using that Pipe ID. See Also Bend & Miter Piping Components - Modeling Approaches, Tips, Techniques Bentley AutoPIPE
↧