Hello Lucky,
This is only a warning for the user to know that a specific pipe joint is beyond the typical SIF calculations required by the selected piping code. Even if you do specify a user SIF at the location the warning message will still appear. Again, it is only a warning for the use to know that attention is needed, but if already addressed/accepted then can be ignored on the model consistency check report.
Regards,
Mike Dattilio
Bentley Technical Support Analyst
Web: http://selectservices.bentley.com/
Create your Service Request online! Log in to SELECTservices Online via http://selectservices.bentley.com/ and then go to My Support Account > Service Request Manager. You'll have the ability to create a new Service request, view all Service Requests created by you or anyone else in your company, and view statistics on previous requests.