Applies To Product(s): Plantflow Version(s): 06.02.xx.xx and higher Environment: N/A Area: Download, Install, License Subarea: Original Author: Bentley Technical Support Group Note : Bentley PlantFLOW is compatible Windows XP, Windows Vista, Windows Vista x64, Windows XP x64, Windows 7, Windows 7 x64. 1. Download PlantFLOW Open internet explorer web site http://selectservices.bentley.com/en-US/ Select “ Download New software online” Log into web site Follow the general instructions outlined on this WIKI here for AutoPIPE in order to download PlantFLOW 2. Install PlantFLOW This new version of PlantFLOW is able to run on 32 bit and 64 bit versions of Windows XP, VISTA, & 7 Uninstall previous version of PlantFLOW Back up your existing project files From the Control Panel> select Add or Remove Programs Select PlantFLOW Press the “Change/Remove” button. Complete the process to remove/delete the application. Delete Plant flow folder from computer hard drive. Locate the PlantFLOW file downloaded, unzip to a folder. Select “Start”, “Run”, “Browse”, browse for “ Setup.exe ” inside the extracted folder. Accept all default settings. Do not start the application at the tim 3. Download Bentley IEG Download Bentley IEG Use the same procedure above to download Bentley IEG 02.00.20.01 4. Install Bentley IEG (This is a separate install and is required). IEG must be installed by user with Admin privileges and cannot be pushed over a network connection. Please confirm you are logged on as an admin user, do not assume Un-install any previously installed version of Bentley IEG License Service from Control Panels 'Add or Remove Programs' Select “Start” , “Run”, “Browse”; open the folder where you downloaded the application too or insert the CD and run “iegls02002001en.msi” to start the installation process. Verify that the application installed, Control Panel> Add/Remove Programs> Bentley IEG should be listed. If was not installed, means that the application was only unzipped to the computer system; to complete the installation goto C:\BentleyDownloads\ieg02002001en and run the iegls02002001en.msi application. After installation, the computer should be rebooted. 6. Set- up License Open License Management Tool by using one of the following methods: Start PlantFLOW, select PlantFLOW Demo button, Select Tools> Settings> License Management Tool. Open windows run utility, Start> Run> type “ licensetool ” and press OK button. Search your entire hard drive for “ Licensetool.exe”, should be located under one of the following Verify PlantFLOW licenses are listed on the License Checkout screen and at least 1 license is available for check out. If not, verify the Server Name and Site Activation Key, Tools> Options> press the test connection button. Should see the following. If not, Contact Bentley Licensing group. 6. Start PlantFLOW software Select the PlantFLOW program icon from: Start> Program> Bentley Engineering> PlantFLOW V8i > PlantFLOW V8i The Welcome to PlantFLOW screen will appear. Select the version button listed on your contract: PlantFLOW Standard or PlantFLOW Plus If licensing was correctly installed, the application is now checking for an available license to check out from the License Management Tool. If a valid license has been located, the “Welcome to PlantFLOW 6.2” screen disappears and the application is ready for use. Verify application is not in DEMO mode by inspecting the top of the application bar. The specified licensed version name should appear in the applications bar at the top of the application window. Application indicates Plus license in use Application is in DEMO mode See Also Bentley AutoPIPE External Links Bentley Technical Support KnowledgeBase Bentley LEARN Server Comments or Corrections? Bentley's Technical Support Group requests that you please submit any comments you have on this Wiki article to the "Comments" area below. THANK YOU!
↧