| Applies To | |||
| Product(s): | AutoPIPE, | ||
| Version(s): | 2004, XM, & V8i | ||
| Environment: | Enhancements | ||
| Area: | |||
| Subarea: | |||
| Original Author: | Bentley Technical Support Group | ||
The following Dynamic Analsyis enhancements have been logged for inclusion into a future version of AutoPIPE:
CAE-CR-10998 Program should block dynamic analysis if static analysis set #1 not analyzed
Program should block dynamic analysis if first analysis set not analyzed. There is an internal limitation of the program that the first static analysis set should always be selected for analysis if there is any dynamic analysis to be performed for the model. AutoPIPE historically had only 1 load set prior to 9.1.0, all of the definitions related to dynamic load cases etc used to be associated with this single load set. In the new system – this older load set is mapped to the first static analysis set.
Corrected Version: 9.6.0.10CAE-CR-4560: Add the ability to import time history load file from Bentley HAMMER.
Corrected Version: TBD
.
See Also
External Links
Bentley Technical Support KnowledgeBase
Comments or Corrections?
Bentley's Technical Support Group requests that you please submit any comments you have on this Wiki article to
the "Comments" area below. THANK YOU!