Applies To Product(s): AutoPIPE, Version(s): 2004, XM, & V8i Environment: N/A Area: combinations Subarea: Original Author: Bentley Technical Support Group Comments, Questions, and Answers about No-code combinations in AutoPIPE Item #1: How to set up a non-code combination to print 0.3*gravity when axial displacement at a support exceeds 1/8" in thermal load case? Answer : We apologize for the inconvenience, but there is no mechanism to have a combination set up based on a value result in another combination. You can filter the output report based on values (see Results Filter Criteria) , but you would still need to manually create the combination that can be enabled to be printed or not (see Tools Combination non-code tab print option). Item #2, question: I can not get the pressure into my calculation report. I have defined it in the pressure and temperature definition - I ned to make a load combination of GR+T1+P1. Additionally I want to have the loadcase "hydrotest". I need restraint reactions from: P1, Combined GR+T1+P1 and hydrotest. Answer: First create a Hydrotest case using Load Hydrotest, and then under Loads Static Analysis Sets be sure to check ON: Gravity, Temperature, and "Calculate pressure extension cases, e.g. P1, P2, etc". Now create a 2nd analysis set with only Hydrotest enabled. After the analysis sets have been defined, run the analysis and select Tools Combinations non-code comb tab. Note that the GRT1P1 & Hyrotest load case have already been created. See Also Bentley AutoPIPE External Links Bentley Technical Support KnowledgeBase Bentley LEARN Server Comments or Corrections? Bentley's Technical Support Group requests that you please submit any comments you have on this Wiki article to the "Comments" area below. THANK YOU!
↧