Hello HVN, Your original question: " I tried to determine how one should include WJSRF's at the piping welds Here's what I found of how I think it should be inserted at only those locations that contain welds - can anyone confirm if Im correct?" As mentioned in the online help, there are 3 methods to apply these factors. Please read each method and determine which one you want to use. Again you will need to determine which method is applicable to you and your model. Bentley Tech support cannot explicitly tell you which one to use, only provide information on what will happen by using one method or the other. If you feel that the factor is only to be applied at those specific weld locations and not every node point in the model or pipe_Id points, then please use method number 2 from the online help section previously mentioned. Regards, Mike Dattilio Bentley Technical Support Analyst Web: selectservices.bentley.com Create your Service Request online! Log in to SELECTservices Online via selectservices.bentley.com and then go to My Support Account Service Request Manager. You'll have the ability to create a new Service request, view all Service Requests created by you or anyone else in your company, and view statistics on previous requests.
↧